Find out how to polish a wooden floor with this step by step

 Find out how to polish a wooden floor with this step by step(cost to resurface hardwood floors)

Repairing and vitrifying a hardwood floor may appear to be a mind boggling position, yet it's actually something we can do ourselves. Here we disclose to you how. 

Prior to starting 

Eliminate all furnishings and residue covers from the rooms where it will be vitrified. 

Seal the entryways with plastic so dust doesn't pass. 

Check the state of the wooden floor, since it cannot be polished or vitrified if there is any palmette or board 

Clear or vacuum the floor, as any particles that scratch the floor must be taken out when polishing. 

one 

To stick free parquet you can utilize a plastic paste that leaves a thick and firm adhesive layer where the free pad will settle. 

two 

On the off chance that there are openings or cracks in the wooden boards, they can be filled by making a blend of the same sawdust or residue that originates from polishing and a little virus stick. Or on the other hand with virgin wax, which liquefies in the hand and is spread with a spatula to fill the opening, when it cools it tends to be sanded and acquires the tone of the remainder of the floor. 

three 

The polishing machine has a roller, where the sandpaper is placed, which rotates at rapid to polish the floor. It starts with the 80 sandpaper that makes a coarse polish. Pass the sander over the whole surface, it is done in long and straight segments, making an effort not to stop between each pass so that there are no sanding lopsidedness. 

four 

Change the sandpaper for one of 100, which will make a better polish. Run the sanding machine over the whole surface again. 

five 

Change the sandpaper for one of 120 that will give the best and final polish. Run the sanding machine over the whole surface again. 

six 

The edges and edges of the floor are sanded with the edger, which is a smaller machine with a round circle that reaches all the corners. (hardwood floor refinishing colors)

seven 

With a manual scraper, it improves the completion of the polishing, eliminating stains from the old vitrified or bringing down any lopsidedness. The scraper is very sharp so you don't have to apply a ton of power. 

eight 

Although the polishing machines bring material bags where they oust the residue, after getting done with the sanding it is necessary to vacuum the whole floor and the edge very well with the residue covers. Supplement the cleaning by cleaning with a damp fabric that absorbs the stuck residue. 

nine 

Weaken the vitrifier with half turpentine and apply the main coat of polyurethane vitrifier with a wide brush. Let dry for 24 hours. 

ten 

When the primary coat is dry, with the 400 sandpaper, polish the floor to eliminate hairs or build up.